Abstract:

The success of sand fixation projects in deserts is dependent on soil hydrothermal conditions, which are essential for the healthy growth of sand fixation plants. Vertical pipe surface drip irrigation is a new water-saving and temperature-control conservation technology focused on combating soil drought and surface heat stress on seedlings. However, the mechanisms regulating hydrothermal distribution and migration status remain unclear, and its widespread application in sand-fixing areas lacks a theoretical formulation. Thus, this study constructed a mathematical model of soil water-heat migration for vertical tube surface drip irrigation using HYDRUS-2D software. The study investigated the effects of key irrigation parameters (drip head flow rate and irrigation water temperature) and vertical tube parameters (tube diameter and burial depth) on soil water-heat distribution and migration. The accuracy of the constructed model was confirmed through indoor experiments. Consequently, a single-factor analysis was conducted involving nine simulation scenarios to study the impacts of four influencing factors—drip head flow rate (1, 2, and 3 L·h^-1), irrigation water temperatures (10, 20, and 30 ℃), riser diameter (9.6, 11.6, and 13.2 cm), and riser depth (15, 20, and 25 cm) to obtain the distributions and migration patterns of the soil hydrothermal properties. The results showed the following. (1) Soil hydrothermal changes during irrigation occurred through water-heat coupling influenced by irrigation water temperature. Dynamic changes were most pronounced in the early stage of irrigation, particularly in the inner surface layer of the tube. Over time, these changes stabilized. Water infiltration from the bottom holes of the tube into the surrounding soil increased the soil moisture rapidly before stabilizing. Further, the soil temperature was affected by the irrigation water temperature, exhibiting slight increases or decreases. (2) The diameter of the vertical tube had a minimal effect on the soil hydrothermal changes during drip irrigation. However, the burial depth had a significant influence on the soil moisture but minimal impact on the thermal environment. Outside the tube, the soil moisture distribution around the tube formed a distinct pattern, with the bottom of the tube functioning as a dividing line. Above this line, the soil moisture content at the same point decreased as the burial depth increased, while below this line, the soil moisture content increased with greater burial depth. (3) The drip head flow was a critical factor in determining the soil moisture status although its impact on the soil temperature distribution was limited. The larger the drip head flow, the higher the soil moisture content at the same points outside the pipe. (4) The influence of the irrigation water temperature on the soil moisture distribution was relatively weak; however, it directly influenced the soil temperature. Higher irrigation water temperatures resulted in increased soil temperature at the same points inside and outside the pipe. (5) When adjustments to the vertical tube’s diameter and burial depth were not feasible, soil hydrothermal conditions in the root zone could be effectively regulated by adjusting the drip head flow rate and irrigation water temperature. Thus, this study offers a scientific basis for the design, operation, and management of a vertical pipe surface drip irrigation project for sand fixation plants.

Key words: irrigation, infiltration, hydrothermal transport, numerical simulation, vertical tube surface drip irrigation